Electra Elite IPK Document Revision 4
Programming Manual 2 - 593
___________________________________________________________________________________
___________________________________________________________________________________
Notes
Programming Procedures
1 Go off-line.
2 Press LK4 +
FI
to access the Memory Block.
3 Press the Line Key corresponding to CO Message Waiting Indication required for Tel Port No.
The LED indication changes to indicate data each time a CO/PBX Line Key is pressed:
Off Not assigned
On Red: Assigned
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page
A to go to the previous page
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
4 Press
G to write the data and advance to the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-07
Class of Service (Attendant) Feature Selection 1
Page 3, LK 2
3-73
CO Message Waiting Yes/No Selection
This assignment is valid for Multiline Terminals only.
To Next Page
Loading...
