3 - 50 Advanced Applications
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
• When incoming and outgoing calls are processed simultaneously
the incoming call has priority. A collision error between
simultaneous SETUP messages is generated, and the outgoing
call gets a busy signal.
H
The Incoming/outgoing (IC/OG) SFG must be equal to or greater than
the outgoing (OG) SFG. When not, In many cases, the Electra Elite
system does not accept an incoming call.
H
When Operator Call Time Out Table is set to 0 in LCR Programming, the
operator call requiring more than 1 digit cannot be used. When 0 + any
digits is stored in speed dial, the system sends the call as 0 Call
(operator) only.
To Next Page
Loading...
