NEC Electra Elite IPK - Page 787

A - 2 Function Time Chart
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
CO/PBX Incoming
Ringing Alarm Time
Selection
1-1-06* The time after an incoming
CO/PBX call is detected before
the ringing tone changes to a
different ringing tone level
when the call is not answered.
10s
000s
(No Limit)
∞
000s
∞
255s
Tie Line Delay
Ringing Time
Selection
1-1-07* The time between when a
telephone rings (accessed by a
ringing call in the Tie/DID line)
and calls can start ringing at
other assigned stations when it
is not answered.
10s
000s
(No Limit)
∞
000s
∞
255s
Station Transfer/
Camp-On Recall
Time Selection
1-1-12* The time before a ring
transferred call recalls to the
station that transferred the call.
25s
000s
(No Limit)
45s
060s
∞
999s
Trunk Queuing
Timeout Selection
1-1-37* The time a station with Trunk
Queue set rings before the
queue is automatically
canceled.
10s
00s
(No Limit)
10s
10s
60s
99s
CO/PBX Prepause
Time Selection
1-1-57 The time before dialed digits
are sent over a CO/PBX line
after the line is seized.
NON 1s 13s
Hold Recall Time
Selection
(Exclusive)
1-1-63* The time (minutes) for
Exclusive Hold Recall. No limit
disables this feature.
0.5
000s
(No Limit)
1.0
060s
∞
999s
First Delay
Announcement
Start Time
Selection
1-1-71 The time (seconds) between
receiving an incoming CO call
and sending the First Delay
Announcement to the caller.
00 20 60
First to Second
Delay
Announcement
Interval Time
Selection
1-1-73 The time (seconds) between
the end of the First Delay
Announcement and the
beginning of the second
Second Delay Announcement.
00 20
∞
Second Delay
Announcement
Repeat Interval
Time Selection
1-1-75 The time (seconds) to repeat
the Second Delay
Announcement.
020
∞
Table A-1 Function Time Chart (Continued)
Time
Memory
Block
Definition
Value
Minimum Default Maximum