NEC Electra Elite IPK - Page 789

A - 4 Function Time Chart
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
Hookflash Start
Time Selection
1-3-05 The minimum hookflash time
(milliseconds) for a Single Line
Telephone or Voice Mail
System before a valid
hookflash is detected.
40 290 790
Hookflash End
Time Selection
1-3-06 The maximum hookflash time
from a Single Line Telephone
to receive a second dial tone
(HST = Hookflash Start Time).
00
(HST + 0
ms.)
07
(HST + 700
ms.)
15
(HST +
1500 ms.)
Voice Mail DTMF
Delay Time
Selection
1-3-08 The delay time before DTMF
tones are sent from the VMI
port.
0s 1s 8s
Voice Mail
Disconnect Time
Selection
1-3-09 The time a disconnect signal is
sent to Voice Mail equipment.
0.5s 1.5s 3.5s
Voice Mail DTMF
Duration/Interdigit
Time Selection
1-3-10 The DTMF duration/interdigit
time (milliseconds) for voice
mail.
60/70 110/80 810/190
Tandem Transfer
Automatic
Disconnect Time
Selection
1-4-00 The maximum time (minutes)
before the system automatic
disconnects a Trunk-to-Trunk
connection.
000 060 999
Automated
Attendant First Digit
PBR Release Time
Selection
1-4-01* The time a PBR circuit remains
connected after the Automated
Attendant message is played
when a call comes in through
an Automated Attendant trunk.
5s
01s
20s
20s
60s
99s
Automated
Attendant Transfer
Delayed Ringing
Time Selection
1-4-02* The time a call rings at the
destination before the
Automated Attendant rings a
predetermined station.
10s
00s
(No Limit)
∞
00s
∞
99s
Automated
Attendant No
Answer Disconnect
Time Selection
1-4-03* The time the Automated
Attendant rings a station before
automatic disconnect.
1m
001s
2m
120s
4m
255s
Automated
Attendant Answer
Delay Time
Assignment
1-4-13 The time before the Automated
Attendant answers an incoming
CO/PBX call.
00s 04s 99s
Table A-1 Function Time Chart (Continued)
Time
Memory
Block
Definition
Value
Minimum Default Maximum