NEC Electra Elite IPK - Page 84

Electra Elite IPK Document Revision 4
Programming Manual 2 - 7
___________________________________________________________________________________
___________________________________________________________________________________
Display (R3000 or higher)
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1
+ KC to access the Memory Block.
3 Use the dial pad to enter the Data Setting for Class 1.
Setting Data
000s~255s (e.g., 045s = 45s)
Default Values
Class 1~4 = 060s
000s = No Limit
4 Press G to write the data and display the next Timer Class of Service.
5 Program the next Timer Class of Service or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-63
Hold Recall Time Selection (Exclusive)
1-2-23
System Call Park Recall Time Selection
4-71
Station to Timer Class of Service (R3000 or higher)
1. Calls put on Exclusive Hold, recall using the data selected in Memory Block 1-1-63 [Hold Recall Time Selection
(Exclusive)].
2. Calls placed on hold on Call Appearance keys, recall using this Memory Block.
3. Calls parked in System Call Park locations recall using Memory Block 1-2-23 (System Call Park Recall Time
Selection).
4. Telephone ports 1 and 2 are in Station to Timer Class of Service, Class 1 by default. All other ports are in Station
to Timer Class of Service, Class 2 by default (R3000 or higher)
.
5. When a system is upgraded from R2500 or lower, the Hold Recall Time Selection is reset to the default value
during the upgrade process (R3000 or higher)
.
0 3 : H L D R C L 1 = 0 6 0 s
T I M E D I S P L A Y
Timer
Class
1~4
Title
Data
No.
Setting
Data