54-1
Chapter 54 Commands for IPv6
Security RA
54.1 ipv6 security-ra enable
Command:
ipv6 security-ra enable
no ipv6 security-ra enable
Function:
Globally enable IPv6 security RA function, all the RA advertisement messages will not be forwarded
through hardware, but only sent to CPU to handle. The no operation of this command will globally
disable IPv6 security RA function.
Command Mode:
Global Configuration Mode.
Default:
The IPv6 security RA function is disabled by default.
Usage Guide:
Only after enabling the global security RA function, the security RA on a port can be enabled.
Globally disabling security RA will clear all the configured security RA ports. The global security RA
function and the global IPv6 SAVI function are mutually exclusive, so they can not be enabled at the
same time.
Example:
Globally enable IPv6 security RA.
Switch(config)#ipv6 security-ra enable
54.2 ipv6 security-ra enable
Command:
ipv6 security-ra enable
no ipv6 security-ra enable
Function:
Enable IPv6 security RA on a port, causing this port not to forward the received RA message. The
no ipv6 security-ra enable will disable the IPv6 security RA on a port.
Command Mode:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
