Planet SGS-6341-24T4X - Sntp Polltime; Sntp Server

68-9
Example:
Displaying debugging information for SNTP packet.
Switch#debug sntp packet
68.3 sntp polltime
Command:
sntp polltime <interval>
no sntp polltime
Function:
Sets the interval for SNTP clients to send requests to NTP/SNTP; the “no sntp polltime” command
cancels the polltime sets and restores the default setting.
Parameters:
<interval> is the interval value from 16 to 16284.
Default:
The default polltime is 64 seconds.
Command Mode:
Global Mode
Example:
Setting the client to send request to the server every 128 seconds.
Switch#config
Switch(config)#sntp polltime128
68.4 sntp server
Command:
sntp server {<ip-address> | <ipv6-address>} [source {vlan <vlan no> | loopback <loopback
no>}] [version <version_no>]
no sntp server {<ip-address> | <ipv6-address>} [source {vlan <vlan no> | loopback
<loopback no>}] [version <version_no>]
Function:
Enable the specified time server as clock source, the no command deletes the specified time
server.
Parameters: