Planet SGS-6341-24T4X - Show Ip Ospf Neighbor

35-225
Hello due in 00:00:16
Neighbor Count is 0, Adjacent neighbor count is 0
35.58 show ip ospf neighbor
Command:
show ip ospf [<process-id>] neighbor [{<neighbor_id> |all |detail [all] |interface <ifaddress>}]
Function:
Display the OSPF adjacent point messages.
Parameter:
<process-id> is the process ID ranging between 0~65535
<neighbor_id> is the dotted decimal notation neighbor ID
all: Display messages of all neighbors
detail: Display detailed messages of all neighbors
<ifaddress> Interface IP address
Default:
Not displayed
Command Mode:
Admin and configuration mode
Usage Guide:
OSPF neighbor state can be checked by viewing the output of this command.
Example:
Switch#show ip ospf neighbor
OSPF process 0:
Neighbor ID Pri State Dead Time Address Interface
192.168.1.1 1 Full/Backup 00:00:32 6.1.1.1 Vlan1
192.168.1.3 1 Full/DR 00:00:36 20.1.1.3 Vlan2
192.168.1.3 1 Full/ - 00:00:30 20.1.1.3 VLINK2
Displayed information
Explanation
Neighbor ID
ID Neighbor ID
Priority
Priority
State
Neighbor relation state
Dead time
Neighbor dead time
Address
Interface Address
Interface
Interface name