Planet SGS-6341-24T4X - Show Cluster Members

SGS-6341 Series Command Guide
3-120
Number of Candidates: 3
----in a member ----------------------------
Switch#show cluster
Status: Enabled
Cluster VLAN: 1
Role: Member
Commander Ip Address: 10.254.254.1
Internal Ip Address: 10.254.254.2
Commamder Mac Address: 00-12-cf-39-1d-90
---- a candidate ----------------------------
Switch#show cluster
Status: Enabled
Cluster VLAN: 1
Role: Candidate
---- disabled ----------------------------
Switch#show cluster
Status: Disabled
3.15 show cluster members
Command:
show cluster members [id <member-id> | mac-address <mac-addr>]
Function:
Display member information of a cluster. This command can only apply to commander switches.
Parameters:
member-id: member id of the switch.
mac-addr: the CPU mac addresses of member switches.
Default:
No parameters means to display information of all member switches.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Executing this command on a commander switch will display the configuration information of all cluster member
switches.
Example:
Execute this command on a commander switch to display the configuration information of all and specified cluster
member switches.