15-131
Default:
The default intp value is 0.
Command mode:
Port Mode.
Usage Guide:
Configure the default internal priority of the port. If there is no dscp and cos fields of the trust
packets, the ingress packet of the port will obtain a default internal priority. The packet's internal
priority may be reset according to the configured QoS policy.
Example:
Configure the default intp value as 40 on ethernet 1/0/1.
Switch(config)#interface ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)#mls qos internal-priority 40
15.10 mls qos map
Command:
mls qos map {cos-intp <intp1…intp8> | dscp-intp <in-dscp list> to <intp> | intp-cos <intp list>
to <out-cos> | intp-dp <intp list> to <out-dp> | intp-dscp <intp list> to <out-dscp>| <color>
intp-intp <intp list> to <intp> | intp-queue <intp list> to <out-queue> }
no mls qos map {cos-intp | dscp-intp | intp-cos | intp-dp | intp-dscp | intp-intp <color> |
intp-queue}
Function:
Set the priority mapping of QoS, the no command restores the default mapping.
Parameters:
cos-intp <intp1…intp8> defines the mapping from CoS value to intp (internal priority), each intp
value is delimited with space, <intp1..intp8> are 8 intp value corresponding to the 0 to 7 CoS value;
dscp-intp defines the mapping from DSCP to intp, <in-dscp list> stand for incoming DSCP values,
up to 8 values are supported, each value is delimited with space, ranging from 0 to 63, <intp> is the
internal priority value, ranging from 0 to 119;
intp-cos defines the mapping from intp to CoS, <intp list> stand for incoming int-prio values, up to 8
values are supported, each value is delimited with space, ranging from 0 to 119, <out-cos> is the
cos output value, ranging from 0 to 7;
intp-dp defines the mapping from intp to dp, <intp list> stand for incoming int-prio values, up to 8
values are supported, each value is delimited with space, ranging from 0 to 119, <out-dp> is the dp
output value, ranging from 0 to 1;
intp-dscp defines the mapping from intp to DSCP, <intp list> stand for incoming int-prio values, up
to 8 values are supported, each value is delimited with space, ranging from 0 to 119, <out-dscp> is
To Next Page
Loading...
