Planet SGS-6341-24T4X - Clear Ipv6 Mld Group

45-56
Command:
show ipv6 multicast source-control access-list
show ipv6 multicast source-control access-list <8000-8099>
Function:
Display the configured IPv6 source control multicast access list.
Parameters:
<8000-8099>: Access list number.
Command Mode:
Admin Mode.
Usage Guide:
Use this command to display the configured source control multicast access list.
Example:
switch#sh ipv6 multicast source-control access-list
ipv6 access-list 8000 permit 2003::2/64 ff1e::3/64
ipv6 access-list 8000 deny 2008::1/64 ff1e::1/64
45.7 Commands for MLD
45.7.1 clear ipv6 mld group
Command:
clear ipv6 mld group [ X:X::X:X | IFNAME ]
Function:
Delete the group record of the specific group or interface.
Parameters:
X:X::X:X the specific group address; IFNAME the specific interface address.
Command Mode:
Admin Configuration Mode
Usage Guide:
Use show command to check the deleted group record.
Example:
Delete all groups.
Switch#clear ipv6 mld group
Relative Command:
show ipv6 mld group