Planet SGS-6341-24T4X - Ip Igmp Snooping Vlan Limit

44-110
query source address configuration does not function. The client will stop sending requesting
datagrams after one is sent. And after a while, it can not receive multicast datagrams.
Example:
Switch(config)#ip igmp snooping vlan 2 L2-general-query-source 192.168.1.2
44.10.10 ip igmp snooping vlan
l2-general-querier-version
Command:
ip igmp snooping vlan <vlanid> L2-general-query-version <version>
Function:
Configure igmp snooping.
Parameters:
vlan-id is the id of the VLAN, limited to <1-4094>. version is the version number, limited to <1-3>.
Command Mode:
Global mode.
Default:
version 3.
Usage Guide:
When the switch is connected to V1 and V2 capable environment, and for VLAN which has source
of layer 2 query configuration, the VLAN can be queried only if the version number has been
specified. This command is used to query the layer 2 version number.
Example:
Switch(config)#ip igmp snooping vlan 2 L2-general-query-version 2
44.10.11 ip igmp snooping vlan limit
Command:
ip igmp snooping vlan <vlan-id> limit {group <g_limit> | source <s_limit>}
no ip igmp snooping vlan <vlan-id> limit
Function:
Configure the max group count of VLAN and the max source count of every group. The “no ip igmp
snooping vlan <vlan-id> limit” command cancels this configuration.
Parameter:
<vlan-id> is the VLAN number.