Planet SGS-6341-24T4X User Manual

33-147
no ip rip authentication key-chain
Function:
Use this command to enable RIPV2 authentication on an interface and further configures the
adopted key chain. The “no ip rip authentication key-chain” command cancels the authentication.
Parameter:
<name-of-chain> is the name of the adopted key chain. There may be spaces in the string. The
input ends with an enter and the string should not be longer than 256 bytes.
Command Mode:
Interface Configuration Mode.
Usage Guide:
If the authentication is only configured without configuring the key chain or password used by the
interface, the authentication does no effect. If mode has not been configured prior to configuring this
command, the mode will be set to plaintext authentication. The “no ip rip authentication key”
command will cancel the authentication which only cancels the authentication process when
sending or receiving data packet other than set non authentication mode.
Example:
Switch# config terminal
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)# ip rip authentication key my key
Relevant Commands:
key, key chain
33.14 ip rip authentication mode
Command:
ip rip authentication mode {text|md5}
no ip rip authentication mode {ext|md5}
Function:
Configure the authentication mode; the “no ip rip authentication mode {ext|md5}” command
restores to the default authentication mode namely text authentication mode.
Parameter:
text means text authentication; md5 means MD5 authentication.
Default:
Not configured authentication.
Command Mode:
Interface Configuration Mode.
Usage Guide:

Planet SGS-6341-24T4X Specifications

General

Switch type	Managed
Switch layer	L3
Quality of Service (QoS) support	Yes
Form factor	1U
Certification	FCC Part 15 Class A, CE
Product color	Black
Console port	RJ-45
SFP+ module slots quantity	4
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	24
Routing entries	128
Networking standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3ae, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Virtual LAN features	Stacked VLAN, Private VLAN, Tagged VLAN, Protocol-based VLAN
Copper ethernet cabling technology	10BASE-T, 100BASE-T, 1000BASE-T
Flash memory	16 MB
Internal memory	512 MB
Processor frequency	400 MHz
Authentication	MAC-based authentication, Port-based authentication
Security algorithms	SNMPv3, SSH, SSL/TLS
Throughput	95.24 Mpps
Jumbo frames	9216
Number of queues	8
MAC address table	16000 entries
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power supply included	-
Power consumption (max)	19.9 W
Heat dissipation	67.91 BTU/h
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 90 %
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	240 mm
Width	440 mm
Height	43.6 mm
Weight	3170 g