Planet SGS-6341-24T4X User Manual

12-48
Usage Guide:
After enabling dot1q-tunnel on the port, data packets without VLAN tag (referred to as tag) will be
packed with a tag when entering through the port; those with tag will be packed with an external tag.
The TPID in the tag is 8100 and the VLAN ID is the VLAN ID the port belongs to. Data packets with
double tags will be forwarded according to MAC address and external tag, till the external tag is
removed when transmitted outside from the access port. Since the length of the data packet may be
over sized when packed with external tag, it is recommended to use this command associating the
Jumbo function. Normally this command is used on access ports, and also on trunk ports however
only when associating the VLAN translation function. This command and dot1q-tunnel tpid are
mutually exclusive.
Example:
Join port1 into VLAN3, enable dot1q-tunnel function.
Switch(config)#vlan 3
Switch(Config-Vlan3)#switchport interface ethernet 1/0/1
Switch(Config-Vlan3)#exit
Switch(config)#interface ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)# dot1q-tunnel enable
Switch(Config-If-Ethernet1/0/1)# exit
Switch(config)#
12.1.4 dot1q-tunnel tpid
Command:
dot1q-tunnel tpid {0x8100|0x9100|0x9200| <1-65535> }
Function:
Configure the type (TPID) of the protocol of switch trunk port.
Command Mode:
Port Mode.
Default:
TPID on the port is defaulted at 0x8100.
Usage Guide:
This function is to facilitate internetworking with equipments of other manufacturers. If the
equipment connected with the switch trunk port sends data packet with a TPID of 0x9100, the port
TPID will be set to 0x9100, this way switch will receive and process data packets normally. This
command and dot1q-tunnel enable are mutually exclusive.
Example:
Set port10 of the switch to trunk port and sends data packet with a TPID of 0x9100.

Planet SGS-6341-24T4X Specifications

General

Switch type	Managed
Switch layer	L3
Quality of Service (QoS) support	Yes
Form factor	1U
Certification	FCC Part 15 Class A, CE
Product color	Black
Console port	RJ-45
SFP+ module slots quantity	4
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	24
Routing entries	128
Networking standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3ae, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Virtual LAN features	Stacked VLAN, Private VLAN, Tagged VLAN, Protocol-based VLAN
Copper ethernet cabling technology	10BASE-T, 100BASE-T, 1000BASE-T
Flash memory	16 MB
Internal memory	512 MB
Processor frequency	400 MHz
Authentication	MAC-based authentication, Port-based authentication
Security algorithms	SNMPv3, SSH, SSL/TLS
Throughput	95.24 Mpps
Jumbo frames	9216
Number of queues	8
MAC address table	16000 entries
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power supply included	-
Power consumption (max)	19.9 W
Heat dissipation	67.91 BTU/h
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 90 %
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	240 mm
Width	440 mm
Height	43.6 mm
Weight	3170 g