EasyManuals Logo

Planet SGS-6341-24T4X User Manual

Planet SGS-6341-24T4X
1206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1112 background imageLoading...
Page #1112 background image
65-5
Specify the access control for the source of the mirror. The no form command will disable this
configuration.
Parameters:
<session> is the session number for the mirror. Currently 1 to 7 is supported. <interface-list> is
the list of source interfaces of the mirror which can be separated by '-' and ';'. <num> is the number
of the access list. rx means to filter the datagram received by the interface. tx for the datagram sent
out, and both means both of income and outcome datagram.
Command Mode:
Global Mode.
Usage Guide:
This command is used to configure the source interfaces for the mirror. It is not restricted the source
interface of the mirror on the switch. The source can be one interface, or can be multiple interfaces.
For flow mirror, only datagram received can be mirrored. The parameters can be rx, tx, both. The
related access list should be prepared before this command is issued. For how to configure the
access list, please refer to ACL configuration. The mirror can only be created after the destination
interface of the corresponding session has been configured.
Example:
Configure the mirror interface 1/0/6 to filter with access list 120 in session 2.
Switch(config)#monitor session 2 source interface 1/0/6 access-list 120 rx
65.3 monitor session destination interface
Command:
monitor session <session> destination interface <interface-number>
no monitor session <session> destination interface <interface-number>
Function:
Specify the destination interface of the mirror. The no form command will disable this configuration.
Parameters:
<session> is the session number of the mirror, which is currently limited to 1-7.
<interface-number> is the destination interface of the mirror.
Command Mode:
Global mode
Usage Guide:
7 destination mirror interface is supported on the switch. To be mentioned. The interface which is
configured as the destination of the mirror should not be configured as the member of the interface
trunk. And the maximum throughput of the interface is recommended to be larger than the total

Table of Contents

Other manuals for Planet SGS-6341-24T4X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planet SGS-6341-24T4X and is the answer not in the manual?

Planet SGS-6341-24T4X Specifications

General IconGeneral
Switch typeManaged
Switch layerL3
Quality of Service (QoS) supportYes
Form factor1U
CertificationFCC Part 15 Class A, CE
Product colorBlack
Console portRJ-45
SFP+ module slots quantity4
Basic switching RJ-45 Ethernet ports typeGigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity24
Routing entries128
Networking standardsIEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3ae, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Virtual LAN featuresStacked VLAN, Private VLAN, Tagged VLAN, Protocol-based VLAN
Copper ethernet cabling technology10BASE-T, 100BASE-T, 1000BASE-T
Flash memory16 MB
Internal memory512 MB
Processor frequency400 MHz
AuthenticationMAC-based authentication, Port-based authentication
Security algorithmsSNMPv3, SSH, SSL/TLS
Throughput95.24 Mpps
Jumbo frames9216
Number of queues8
MAC address table16000 entries
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power supply included-
Power consumption (max)19.9 W
Heat dissipation67.91 BTU/h
Storage temperature (T-T)-10 - 70 °C
Operating temperature (T-T)0 - 50 °C
Operating relative humidity (H-H)5 - 90 %
Harmonized System (HS) code85176990
Weight and Dimensions IconWeight and Dimensions
Depth240 mm
Width440 mm
Height43.6 mm
Weight3170 g

Related product manuals