19-188
19.2.27 ipv6 nd managed-config-flag
Command:
ipv6 nd managed-config-flag
Function:
Set the flag representing whether the address information will be obtained via DHCPv6.
Command Mode
Interface Configuration Mode.
Default:
The address information won’t be obtained via DHCPv6.
Examples:
Set IPv6 address information in interface vlan 1 will be obtained via DHCPv6.
Switch#(Config-if-Vlan1)#ipv6 nd managed-config-flag
19.2.28 ipv6 neighbor
Command:
ipv6 neighbor <ipv6-address> <hardware-address> interface <interface-type
interface-number>
no ipv6 neighbor <ipv6-address>
Function:
Set static neighbor table entry.
Parameters:
Parameter ipv6-address is static neighbor IPv6 address, same to interface prefix parameter,
parameter hardware-address is static neighbor hardware address, interface-type is Ethernet type,
interface-name is Layer 2 interface name.
Command Mode:
Interface Configuration Mode
Default Situation:
There is not static neighbor table entry.
Usage Guide:
IPv6 address and multicast address for specific purpose and local address can not be set as
neighbor.
Example:
Set static neighbor 2001:1:2::4 on port E1/0/1, and the hardware MAC address is
00-30-4f-89-44-bc.
To Next Page
Loading...
