Planet SGS-6341-24T4X - Show Isolate-Port Group

SGS-6341 Series Command Guide
5-143
Only apply port isolation to layer-2 flows on the switch.
Switch(config)#isolate-port apply l2
5.4 show isolate-port group
Command:
show isolate-port group [<WORD>]
Function:
Display the configuration of port isolation, including all configured port isolation groups and Ethernet ports in each
group.
Parameters:
<WORD> the name identification of the group, no longer than 32 characters; no parameter means to display the
configuration of all port isolation groups.
Command Mode:
Admin Mode and Global Mode.
Default:
Display the configuration of all port isolation groups.
Usage Guide:
Users can view the configuration of port isolation with this command.
Example:
Display the port isolation configuration of the port isolation group named as “test”.
Switch(config)#show isolate-port group test
Isolate-port group test
The isolate-port Ethernet1/0/5
The isolate-port Ethernet1/0/2