Planet SGS-6341-24T4X - Ipv6 Router Rip

34-174
Function:
Permit the split horizon. The “no ipv6 rip split-horizon” disables the split horizon.
Parameter:
[poisoned] configures split horizon with poison reverse.
Default:
Split horizon with poison reverse.
Command Mode:
Interface Configuration Mode.
Usage Guide:
The split horizon is for preventing the routing loops, namely preventing the layer 3 switch from
broadcasting a route at the interface from which the very route is learnt. The command can
configure on IPv6 tunnel interface, but it is successful configuration to only configure tunnel
carefully.
Example:
Switch#config terminal
Switch(config)#interface Vlan1
Switch(config-if-Vlan1)#ipv6 rip split-horizon poisoned
34.11 ipv6 router rip
Command:
ipv6 router rip
no ipv6 router rip
Function:
Enable RIPng on the interface. The “no ipv6 router rip” command disables RIPng on the interface.
Default:
Not configured
Command Mode:
Interface Configuration Mode.
Usage Guide:
The command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example:
Switch#config terminal
Switch(config)#interface Vlan1
Switch(Config-if-Vlan1)#ipv6 router rip