Planet SGS-6341-24T4X - Reload Cancel

73-1
Chapter 73 Commands for Reload
Switch after Specified Time
73.1 reload after
Command:
reload after {[<HH:MM:SS>] [days <days>]}
Function:
Reload the switch after a specified period of time.
Parameters:
<HH:MM:SS> the specified time, HH (hours) ranges from 0 to 23, MM (minutes) and SS (seconds)
range from 0 to 59.
<days> the specified days, unit is day, range from 1 to 30.
time and day may be configured at the same time or configured solely.
Command Mode:
Admin mode
Usage Guide:
With this command, users can reboot the switch without shutdown its power after a specified period
of time, usually when updating the switch version. The switch can be rebooted after a period of time
instead of immediately after its version being updated successfully. This command will not be
reserved, which means that it only has one-time effect. After this command is configured, it will
prompt the reboot information when user logging in the switch by telnet.
Example:
Set the switch to automatically reload after 2 days, 10 hours and 1 second.
Switch#reload after 10:00:01 days 2
Process with reboot after? [Y/N] y
Related Commands:
reload, reload cancel, show reload
73.2 reload cancel
Command:
reload cancel