Planet SGS-6341-24T4X - Neighbor Description

37-291
Switch(config-router)#
Then the default route from BGP will appear in partner route list.
Relevant Commands:
route-map
37.51 neighbor description
Command:
neighbor {<ip-address>|<TAG>} description <.LINE>
no neighbor {<ip-address>|<TAG>} description
Function:
Configure the description string of the peer or peer group. The “no neighbor
{<ip-address>|<TAG>} description” command deletes the configurations of this string.
Parameter:
<ip-address>: Neighbor IP address.
<TAG>: Name of peer group.
<.LINE>: Description string consists of displayable characters less than 80.
Default:
Description string is empty.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
Configure the introduction of the peer or peer group.
Example:
Set the description string as tester with neighbor 10.1.1.64.
Switch(config-router)#neighbor 10.1.1.64 description tester
Switch(config-router)#
37.52 neighbor distribute-list
Command:
neighbor {<ip-address>|<TAG>} distribute-list {<1-199>|<1300-2699>|<WORD>} {in|out}
no neighbor {<ip-address>|<TAG>} distribute-list {<1-199>|<1300-2699>|<WORD>} {in|out}
Function: