37-290
route mode and address family mode
Usage Guide:
This command is for settling the problem that multi-connection among peers due to TCP connection
collision. Connections created with this option on will always be check even at established state.
And it will be checked if local side IP is larger than partner IP when collides. If yes, the original
connection will be deleted, and if not the option will be configured to only checks when the
connection originated from local side at open sent and open confirm state.
Example:
Set to perform the TCP connection collision check and settlement with neighbor 10.1.1.64.
Switch(config-router)#neighbor 10.1.1.64 collide-established
37.50 neighbor default-originate
Command:
neighbor {<ip-address>|<TAG>} default-originate [route-map <WORD>]
no neighbor {<ip-address>|<TAG>} default-originate [route-map <WORD>]
Function:
Configures whether enables transmitting default route to the specific neighbor. The “no neighbor
{<ip-address>|<TAG>} default-originate [route-map <WORD>]” command configures not
sending default route to neighbors.
Parameter:
<ip-address>: IP address of the neighbor.
<TAG>: Name of the peer.
<WORD>: Name of route map.
Default:
Not sending default route.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
With this option, the default route of local side will be transmitted to partner, or else not. It supplies
with options of which one to supply the default route. if several neighbors of the partner supply
default route, the best one will be elected according to path selecting principles. According to route
mirror, it can be chosen when to send the default route.
Example:
Set to transmit the local default route to neighbor 10.1.1.64.
Switch(config-router)#neighbor 10.1.1.64 default-originate
To Next Page
Loading...
Need help?
General
Weight and Dimensions
