Planet SGS-6341-24T4X - Neighbor Activate

37-284
{<LISTNAME>|<1-199>|[expanded <WORD>]|[standard <WORD>]} {deny|permit}
<.COMMUNITY>“ command is for deleting the extended community list.
Parameter:
<LISTNAME>: name of community-list.
<1-199>: Standard or extended community number.
<WORD>: Standard or extended community number.
<.COMMUNITY >: Members of the community list, which may be the combination of aa:nn, or
internet, local-AS, no-advertise, and no-export. It can be shown in regular expressions under
extended conditions.
Command Mode:
Global mode
Usage Guide:
With this command we can configure the community-list so to supply terms for the
pass/filter/search.
Example:
Configure the excommunity-list named LN, permit community attribute as 100:10.
Switch(config)# ip extcommunity-list LN permit 100:10
37.42 neighbor activate
Command:
neighbor {<ip-address>|<TAG>} activate
no neighbor {<ip-address>|<TAG>} activate
Function:
Configure the address family routing which do or do not switch specific address-family with BGP
neighbors. The “no neighbor {<ip-address>|<TAG>} activate” command is for setting the route
which do not switch the specified address family.
Parameter:
<ip-address>: IP address of the neighbor.
<TAG>: Name of peer group.
Default:
Enable the routing switch of IP unicast address-family, and disable other address-families.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
IP unicast is configured under BGP route mode. Configure whether specific address-family is
switched under address-family mode. If this option on any side between local side and partner is not