11-30
Function:
Configure the low threshold of errored frame seconds event, no command restores the default
value.
Parameter:
<low-seconds>, the low detection threshold of errored frame seconds event, ranging from 1 to
65535 seconds.
Default:
1.
Command Mode:
Port mode
Usage Guide:
During the specific detection period, errored frame seconds event is induced if the number of
errored frame seconds is larger than or equal to the low threshold and the device notifies the peer
by sending event notification OAMPDU. Note that the low threshold should not be larger than the
high threshold. The definition of errored frame seconds is the second in which errored frame is
received.
Example:
Configure the low threshold of errored frame seconds event on port 1/0/4 to 100.
Switch(Config-If-Ethernet1/0/4)#ethernet-oam errored-frame-seconds threshold low 100
11.15 ethernet-oam errored-frame-seconds window
Command:
ethernet-oam errored-frame-seconds window <seconds>
no ethernet-oam errored-frame-seconds window
Function:
Configure the detection period of errored frame seconds event, no command restores the default
value.
Parameter:
<seconds>, the detection period value of errored frame seconds event, ranging from 10 to 900
secods.
Default:
60.
Command Mode:
Port mode
To Next Page
Loading...
