Planet SGS-6341-24T4X - Import Map

37-281
Usage Guide:
Use this command to exit the mode so to end the address-family configuration when configuring
address-family under BGP.
Example:
Switch(config)#router bgp 100
Switch(config-router)#address-family ipv4 unicast
Switch(config-router-af)# exit-address-family
Switch(config-router)#
Related Command:
address-family
37.38 import map
Command:
import map <map-name>
no import map <map-name>
Function:
Use this command to configure the route-map regulations when introducing routes into VRF.
Parameter:
<map-name> is the route-map name used.
Command Mode:
VRF mode.
Usage Guide:
Use the route map command route-map NAME permit|deny <1-65535> to create the route-map and
establish the regulations. Using this command will apply regulations to the route introducing of this
VRF.
Example:
This example configures a route map1, then configures VRF DC1 to use the route map.
Switch(config)#route-map map1 permit 15
Switch(config-map)#match interface Vlan1
Switch(config-map)#set weight 655
Reconfiguring VRF DC1 with this route-map
Switch(config-map)#exit
Switch(config)#ip vrf DC1
Switch(config-af)#rd 100:10
Switch(config-af)#route-target both 100:10