SGS-6341 Series Command Guide
3-124
3.18 rcommand commander
Command:
rcommand commander
Function:
In the member switch, use this command to configure the commander switch.
Command mode:
Admin Mode.
Instructions:
This command is used to configure the commander switch remotely. Users have to telnet the commander switch by
passing the authentication. The command “exit” is used to quit the configuration interface of the commander switch.
This command can only be executed on member switches.
Example:
In the member switch, enter the configuration interface of the commander switch.
Switch#rcommand commander
3.19 rcommand member
Command:
rcommand member <mem-id>
Function:
In the commander switch, this command is used to remotely manage the member switches in the cluster.
Parameter:
<mem-id> commander the member id allocated by commander to each member, whose range is 1～128.
Command mode:
Admin Mode.
Usage Guide:
After executing this command, users will remotely login to a member switch and enter Admin Mode on the latter. Use
exit to quit the configuration interface of the member. Because of the use of internal private IP, telnet authentication
will be omitted on member switches. This command can only be executed on commander switches.
Example:
In the commander switch, enter the configuration interface of the member switch with mem-id 1.
Switch#rcommand member 1
To Next Page
Loading...
