Planet SGS-6341-24T4X - Ip Ospf Network

35-208
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf mtu 1480
35.35 ip ospf mtu-ignore
Command:
ip ospf <ip-address> mtu-ignore
no ip ospf <ip-address> mtu-ignore
Function:
Use this command so that the mtu size is not checked when switching DD; the “no ip ospf
<ip-address> mtu-ignore” will ensure the mtu size check when performing DD switch.
Parameter:
<ip-address> is the interface IP address show in dotted decimal notation.
Default:
Check mtu size in DD switch.
Command Mode:
Interface Configuration Mode.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf mtu-ignore
35.36 ip ospf network
Command:
ip ospf network {broadcast | non-broadcast | point-to-point | point-to-multipoint}
no ip ospf network
Function:
This command configures the OSPF network type of the interface; the “no ip ospf network”
command restores the default value.
Parameter:
broadcast: Set the OSPF network type to broadcast.
non-broadcast: Set the OSPF network type to NBMA.
point-to-point: Set the OSPF network type to point-to-point.