44-102
Example:
Configure static-group 224.1.1.1 on interface vlan1.
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ip igmp static-group 224.1.1.1
44.9.14 ip igmp version
Command:
ip igmp version <version>
no ip igmp version
Function:
Configure IGMP version on interface; the “no ip igmp version” command restores default value.
Parameter:
<version> is IGMP version of configuration, currently supporting version 1, 2 and 3.
Default:
version 2.
Command Mode:
Interface Configuration Mode
Usage Guide:
The command mainly applies to supply upward compatibility of the different version; it is not
communicated between version 1 and version 2, therefore it must configure to the same version
IGMP in the same network. When other routers which are not upgraded to IGMPv3 on
interface-connected subnet need to join member identity collection of subnet IGMP together, the
interface is configured to corresponding version.
Example:
Configure IGMP on interface to version 3.
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ip igmp version 3
44.9.15 show ip igmp groups
Command:
show ip igmp groups [<A.B.C.D>] [detail]
Function:
Display IGMP group information
Parameter:
To Next Page
Loading...
