31-123
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set atomic-aggregate
31.18 set comm-list
Command:
set comm-list <community-list-name | community-list-num > delete
no set comm-list <community-list-name | community-list-num > delete
Function:
Configure to delete the community attributes from the inbound or outbound routing messages. The
“no set comm-list <community-list-name | community-list-num > delete” command deletes the
configuration.
Parameter:
<community-list-name > is the name of community list, <community-list-num > is the sequence
number of community list, ranging between 1～99（standard community list） or 100～199
（extended community list）.
Command Mode:
route-map mode
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set comm-list 100 delete
31.19 set community
Command:
set community [AA:NN] [internet] [local-AS] [no-advertise] [no-export] [none] [additive]
no set community [AA:NN] [internet] [local-AS] [no-advertise] [no-export] [none] [additive]
Function:
Configure the community attributes of the BGP routing message. The “no set community [AA:NN]
[internet] [local-AS] [no-advertise] [no-export] [none] [additive]” command deletes this
configuration.
Parameter:
[AA:NN] is the community attribute value, [internet] is the internet scope, [local-AS] means this
To Next Page
Loading...
