12-64
remove WORD: Delete the specific VLAN of vlanList from the existent allow vlanList;
Command mode:
Port Mode.
Default:
Forbidden vlanList is empty
Usage Guide:
Tag the corresponding position for forbidden vlanList and clear allow vlanList flags in ports. A port
leaves these VLANs if it joins them statically, and it sends message to GVRP module to enable
corresponding registered machine of the port to enter forbidden mode.
Example:
Port quits the corresponding VLAN and the corresponding registered machine of GVRP to enter
forbidden mode.
Switch(config-if-ethernet1/0/1)#switchport forbidden vlan all
12.1.27 switchport hybrid allowed vlan
Command:
switchport hybrid allowed vlan {WORD | all | add WORD | except WORD | remove WORD}
{tag | untag}
no switchport hybrid allowed vlan
Function:
Set hybrid port which allow the VLAN to pass with tag or untag method; the “no switchport hybrid
allowed vlan” command restores the default setting.
Parameter:
WORD: Set vlan List to allowed vlan, and the late configuration will cover the previous configuration;
all: Set all VLANs to allowed vlan;
add WORD: Add vlanList to the existent allowed vlanList;
except WORD: Set all VLANs to allowed vlan except the configured vlanList;
remove WORD: Delete the specific VLAN of vlanList from the existent allow vlanList;
tag: Join the specific VLAN with tag mode;
untag: Join the specific VLAN with untag mode.
Command mode:
Port Mode.
Default:
Deny all VLAN traffic to pass.
Usage Guide:
The user can use this command to set the VLANs whose traffic allowed to pass through the Hybrid