Planet SGS-6341-24T4X - Ntp Disable

69-6
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)#ntp broadcast client
69.11 ntp broadcast server count
Command:
ntp broadcast server count <number>
no ntp broadcast server count
Function:
Set the max number of broadcast or multicast servers supported by the NTP client. The no
operation will cancel the configuration and restore the default value.
Parameters:
number：1-100, the max number of broadcast servers.
Default:
The default max number of broadcast servers is 50.
Command Mode:
Global Mode.
Examples:
Configure the max number of broadcast servers is 70 on the switch.
Switch(config)#ntp broadcast server count 70
69.12 ntp disable
Command:
ntp disable
no ntp disable
Function:
To disable/enable the NTP function on port.
Default:
To enable NTP function on all ports.
Command Mode:
Interface Configuration Mode.
Example:
To disable the NTP function on vlan1 interface.