Planet SGS-6341-24T4X - Page 1130

69-5
Example:
To enable NTP authentication function.
Switch(config)#ntp authenticate
69.9 ntp authentication-key
Command:
ntp authentication-key <key-id> md5 <value>
no ntp authentication-key <key-id>
Function:
To enable/cancel NTP authentication function, and defined NTP authentication key.
Parameter:
key-id: The id of key, range is from 1 to 4294967295.
value: The value of key, range between 1 to 16 of ascii code.
Default:
The authentication key of NTP authentication is not configured by default.
Command Mode:
Global Mode.
Example:
To define the authentication key of NTP authentication, the key-id is 20, the md5 is abc.
Switch(config)# ntp authentication-key 20 md5 abc
69.10 ntp broadcast client
Command:
ntp broadcast client
no ntp broadcast client
Function:
To configure/cancel the specified port to receive NTP broadcast packets.
Default:
Disabled.
Command Mode:
Interface Configuration Mode.
Example:
Enable the function of VLAN1 interface to receive NTP broadcast packets.