37-315
37.85 redistribute ospf (MBGP4+)
Command:
redistribute ospf [<process-tag>] [route-map<word>]
no redistribute ospf [<process-tag>]
Function:
To redistribute routing information form OSPFv3 to MBGP4+. The no form of this command will
remove the configuration.
Parameters:
process-id is the process character string of the OSPFv3, the length is less than 15. If no process
id is specified, the default process will be used.
route-map<word> is the pointer to the introduced routing map.
Default:
Not redistributed by default.
Command Mode:
BGP IPv6 Configuration Mode.
Example:
To redistribute routing information from OSPFv3 process with the tag as ABC to MBGP4+ (as
number as 1).
Switch (config)#router bgp 1
Switch (config-router)#address-family ipv6 unicast
Switch (config-router-af)#redistribute ospf abc
37.86 router bgp
Command:
router bgp <as-id>
no router bgp <as-id>
Function:
Enable BGP instance. The “no router bgp <as-id>” command deletes BGP instance.
Parameter:
<as-id>: AS number, ranging from 1 to 4294967295, it can be shown in decimal notation (such as
6553700) or delimiter method (such as 100.100).
Default:
BGP not enabled.
Command Mode:
To Next Page
Loading...
