72-21
Command Mode:
Admin mode and configuration mode
Usage Guide:
When failure occurred on the switch, this command can be used to get related information, in order
to diagnose the problems.
Example:
Switch#show tech-support
72.25 show udp
Command:
show udp
Function:
Display the current UDP connection status established to the switch.
Command mode:
Admin Mode
Example:
Switch#show udp
LocalAddress LocalPort ForeignAddress ForeignPort State
0.0.0.0 161 0.0.0.0 0 CLOSED
0.0.0.0 123 0.0.0.0 0 CLOSED
0.0.0.0 1985 0.0.0.0 0 CLOSED
Local address of the UDP connection.
Local pot number of the UDP connection.
Remote address of the UDP connection.
Remote port number of the UDP connection.
Current status of the UDP connection.
72.26 show udp ipv6
Command:
show udp ipv6