Planet SGS-6341-24T4X - Commands for Snmp; Debug Snmp Mib; Debug Snmp Kernel

SGS-6341 Series Command Guide
1-82
Command mode:
VLAN Interface Mode
Usage Guide:
Obtaining IP address by DHCP, Manual configuration and BootP are mutually exclusive, enabling any 2 methods for
obtaining an IP address is not allowed.
Example:
Getting an IP address through DHCP.
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip dhcp-client enable
Switch(Config-if-Vlan1)#exit
Switch(config)#
1.4 Commands for SNMP
1.4.1 debug snmp mib
Command:
debug snmp mib
no debug snmp mib
Function:
Enable the SNMP mib debugging; the "no debug snmp mib” command disables the debugging.
Command Mode:
Admin Mode.
Usage Guide:
When user encounters problems in applying SNMP, the SNMP debugging is available to locate the problem causes.
Example:
Switch#debug snmp mib
1.4.2 debug snmp kernel
Command:
debug snmp kernel
no debug snmp kernel
Function:
Enable the SNMP kernel debugging; the “no debug snmp kernel” command disables the debugging function.
Command Mode:
Admin Mode.