12-73
12.1.39 vlan-translation miss drop
Command:
vlan-translation miss drop in
no vlan-translation miss drop in
Function:
Set packet dropping when checking vlan-translation is failing; the no command restores to the
default value.
Parameter:
In refers to ingress..
Command Mode:
Port Mode.
Default:
Do not drop the packets when checking vlan-translation is failing.
Usage Guide:
When performing the mapping translation between the original and the current VID, if no
corresponding translation is configured, the packet will not be dropped by default, but checking
failure will drop the tag message after use this command, this command is of no effect for untag
message.
Example:
Set ingress packet dropped on port1 when translation failure.
Switch(Config-If-Ethernet1/0/1)#vlan-translation miss drop in
To Next Page
Loading...
Need help?
General
Weight and Dimensions
