12-72
Default:
There is no VLAN translation relation.
Usage Guide:
The command is for configuring the in and out translation relation of the VLAN translation function.
The data packets will be matched according to the configured translation relations, and its VLAN ID
will be changed to the one in the configured item once matched, while the vlan-translation miss drop
command will determine the next forwarding if not match.
Example:
Move the VLAN100 data entered from the port1 to VLAN2 after ingress translation.
Switch#config
Switch(config)#interface ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)#vlan-translation enable
Switch(Config-If-Ethernet1/0/1)#vlan-translation 100 to 2 in
Switch(Config-If-Ethernet1/0/1)#exit
12.1.38 vlan-translation enable
Command:
vlan-translation enable
no vlan-translation enable
Function:
Enable VLAN translation on specified trunk port of the switch; the “no vlan-translation enable”
command restores to the default value.
Command Mode:
Port Mode.
Default:
VLAN translation has not been enabled on the port by default.
Usage Guide:
This command and dot1q-tunnel are mutually exclusive.
Example:
Enable VLAN translation function on port1.
Switch#config
Switch(config)#interface ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)#vlan-translation enable
To Next Page
Loading...
