Planet SGS-6341-24T4X - Page 1073

60-13
Default:
Not configured by default.
Command mode:
VRRP protocol configuration mode
Usage Guide:
This command adds a layer 3 interface to an existing Standby cluster. The "no interface" command
removes the L3 interface from the specified Standby cluster.
Example:
Configuring the interface as "interface vlan 1".
Example:
Switch(config-router)#router vrrp 10
Switch(Config-router)#interface vlan 1
60.7 preempt-mode
Commands:
preempt-mode {true | false}
Function:
Configures the preemptive mode for VRRP.
Command mode:
VRRP protocol configuration mode
Default:
Preemptive mode is set by default.
Usage Guide:
If a router (or L3 Ethernet switch) requiring high priority needs to preemptively become the active
router (or L3 Ethernet switch), the preemptive mode should be enabled.
Example:
Setting non-preemptive VRRP mode.
Switch(Config-Router-Vrrp)#preempt-mode false
60.8 priority
Commands:
priority <value>
Function: