Planet SGS-6341-24T4X - Page 1080

61-4
enable
Function:
Enable VRRPv3 virtual router.
Command Mode:
VRRPv3 Protocol Mode.
Default:
There is no configuration by default.
Usage Guide:
Start the corresponding virtual router session. Only the interface of the enabled router (or the
layer-three switch) can actually join the backup group. Before enabling the virtual router, the virtual
IPv6 address and interface of VRRPv3 should be configured.
Example:
Enable the VRRPv3 virtual router whose ID is 10.
Switch(config)#router ipv6 vrrp 10
Switch(config-router)#enable
61.6 preempt-mode
Command:
preempt-mode {true | false}
Function:
Configure the preempt mode of VRRPv3.
Command Mode:
VRRPv3 Protocol Mode.
Default:
It is preempt mode by default.
Usage Guide:
If it is needed that a router (or a layer-three switch) with higher priority can the role of master router,
the preempt mode needs to be configured.
Example:
Configure VRRPv3 as non-preempt mode.
Switch(config-router)# preempt-mode false