62-6
Command Mode:
Global Mode
Usage Guide:
If this MRPP ring doesn’t exist it create new MRPP ring when executing the command, and then it
enter MRPP ring mode. It needs to ensure disable this MRPP ring when executing the “no mrpp
ring” command.
Example:
Switch(config)#mrpp ring 100
62.10 mrpp ring primary-port
Command:
mrpp ring <ring-id> primary-port
no mrpp ring <ring-id> primary-port
Function:
Specify MRPP ring primary-port.
Parameter:
<ring-id> is the ID of MRPP ring; range is <1-4096>.
Command Mode:
Port mode
Usage Guide:
The command specifies MRPP ring primary port. Primary node uses primary port to send Hello
packet, secondary port is used to receive Hello packet from primary node. There are no difference
on function between primary port and secondary of secondary node.
The mrpp enable command must be enabled before the control-vlan command be used. If primary
port, secondary port, node-mode and enable commands all be configured after control-vlan, then the
mrpp-ring function is enabled.
Example:
Configure the primary of MRPP ring 4000 to Ethernet 1/0/1.
Switch(Config)#interface ethernet 1/0/1
Switch(config-If-Ethernet1/0/1)#mrpp ring 4000 primary-port
62.11 mrpp ring secondary-port
Command:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
