Planet SGS-6341-24T4X - Page 1094

63-2
Configure the sending control VLAN of ULPP group as 10.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# control vlan 10
63.3 debug ulpp error
Command:
debug ulpp error
no debug ulpp error
Function:
Show the error information of ULPP. The no operation disables showing the error information of
ULPP.
Default:
Do not display.
Command mode:
Admin mode.
Example:
Show the error information of ULPP.
Switch# debug ulpp error
Unrecognized Flush packet received.
63.4 debug ulpp event
Command:
debug ulpp event
no debug ulpp event
Function:
Show the event information of ULPP. The no operation disables showing the event information of
ULPP.
Default:
Do not display.
Command mode:
Admin mode.
Example:
Show the event information of ULPP.