72-6
Switch(config)# logging 100.100.100.5 facility local1 level warnings
Example 2:
Send the log information with a severity level equal to or higher than informational to the log server
with an IPv6 address of 3ffe:506:1:2::3, and save to the log recording equipment local5.
Switch(config)#
logging 3ffe:506:1:2::3 facility local1 level informational
72.5 logging executed-commands
Command:
logging executed-commands {enable | disable}
Function:
Enable or disable the logging executed-commands.
Command Mode:
Global mode.
Default:
Disable state.
Usage Guide:
After enable this command, the commands executed by user at the console, telnet or ssh terminal
will record the log, so it should be used with the logging LOGHOST command.
Example:
Enable the command and send the commands executed by user into log host (10.1.1.1)
Switch(Config)#logging 10.1.1.1
Switch(Config)#logging executed-commands enable
72.6 logging loghost sequence-number
Command:
logging loghost sequence-number
no logging loghost sequence-number
Function:
Add the loghost sequence-number for the log; the no command does not include the loghost
sequence-number.
Command Mode:
To Next Page
Loading...
