74-1
Chapter 74 Commands for Debugging
and Diagnosis for Packets Received
and Sent by CPU
74.1 clear cpu-rx-stat protocol
Command:
clear cpu-rx-stat protocol [ <protocol-type> ]
Function:
Clear the statistics of the CPU received packets of the protocol type.
Parameter:
<protocol-type> is the type of the protocol of the packet, including dot1x, stp, snmp, arp, telnet,
http, dhcp, igmp, ssh, bgp, bgp4plus, rip, ripng, ospf, ospfv3, pim, pimv6, unknown-mcast,
unknow-mcast6, mld
Command Mode:
Global Mode
Usage Guide:
This command clear the statistics of the CPU received packets of the protocol type, it is supposed to
be used with the help of the technical support.
Example:
Clear the statistics of the CPU receives ARP packets.
Switch(config)#clear cpu-rx-stat protocol arp
74.2 cpu-rx-ratelimit protocol
Command:
cpu-rx-ratelimit protocol <protocol-type> <packets>
no cpu-rx-ratelimit protocol <protocol-type>
Function:
Set the max rate of the CPU receiving packets of the protocol type, the no command set the max
rate to default.
Parameter:
<protocol-type> is the type of the protocol, including dot1x, stp, snmp, arp, telnet, http, dhcp, igmp,
To Next Page
Loading...
