16-152
Parameters:
1. No specified port, display the information of all the flow-based redirection in the system.
2. Specify ports in <IFNAME>, display the information of the flow-based redirection configured in
the ports listed in the interface-list.
Command Mode:
Admin Mode and Configuration Mode.
Usage Guide:
This command is used to display the information of current flow-based redirection in the
system/port.
Example:
Switch(config)# show flow-based-redirect
Flow-based-redirect config on interface ethernet 1/0/1:
RX flow (access-list 1) is redirected to interface Ethernet1/0/6
To Next Page
Loading...
