Planet SGS-6341-24T4X - Page 321

19-167
Default:
No Layer 3 interface is configured upon switch shipment.
Command mode:
Global Mode
Usage Guide:
When creating a VLAN interface (Layer 3 interface), VLANs should be configured first, for details,
see the VLAN chapters. When VLAN interface (Layer 3 interface) is created with this command, the
VLAN interface (Layer 3 interface) configuration mode will be entered. After the creation of the
VLAN interface (Layer 3 interface), interface vlan command can still be used to enter Layer 3 Port
Mode.
Example:
Creating a VLAN interface (layer 3 interface).
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#
19.1.6 ip vrf
Command:
ip vrf <vrf-name>
no ip vrf <vrf-name>
Function:
Configure the corresponding VPN instance, the no command cancel this VPN instance.
Parameters:
<vrf-name>: Configure the name of VPN instance, the ranging from 1 to 64.
Default:
Not configured.
Command mode:
Global configuration mode.
Usage Guide:
Configure the corresponding VPN instance. There is no default VPN instance on PE, a PE can
create multiple VPN instances and the name distinguishes the capital letter and small letter. Please
pay attention: VPN instance takes effect after configure RD.
Example:
Switch(config)#ip vrf VRF-A
Switch(config-vrf)#