Planet SGS-6341-24T4X - Page 376

23-15
Chapter 23 Command for ARP Local
Proxy
23.1 ip local proxy-arp
Command:
ip local proxy-arp
no ip local proxy-arp
Function:
Enable/disable the local ARP Proxy function of a specified interface.
Default Settings:
This function is disabled on all interfaces by default.
Command Mode:
Interface VLAN Mode.
User Guide:
This function is disabled on all interfaces by default, and differs from the original proxy-arp in that
this function acts as an ARP Proxy inside the same layer-3 interface and thus directs the layer-3
forwarding of the switch.
Example:
Enable the local ARP Proxy function of interface VLAN1.
Switch(Config-if-Vlan1)# ip local proxy-arp