Planet SGS-6341-24T4X - Page 385

26-24
no debug ip dhcp server {events | linkage | packets}
Function:
Enables DHCP server debug information: the “no debug ip dhcp server {events | linkage |
packets}” command disables the debug information for DHCP server.
Command Mode:
Admin Mode.
Default:
Debug information is disabled by default.
26.1.9 default-router
Command:
default-router <address1>[<address2>[…<address8>]]
no default-router
Function:
Configures default gateway(s) for DHCP clients; the “no default-router” command deletes the
default gateway.
Parameters:
<address1>…<address8> are IP addresses, in decimal format.
Default:
No default gateway is configured for DHCP clients by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
The IP address of default gateway(s) should be in the same subnet as the DHCP client IP, the
switch supports up to 8 gateway addresses. The gateway address assigned first has the highest
priority, and therefore address1 has the highest priority, and address2 has the second, and so on.
Example:
Configuring the default gateway for DHCP clients to be 10.1.128.2 and 10.1.128.100.
Switch(dhcp-1-config)#default-router 10.1.128.2 10.1.128.100
26.1.10 dns-server
Command:
dns-server <address1>[<address2>[…<address8>]]
no dns-server