Planet SGS-6341-24T4X - Page 434

29-73
Command:
class <class-name>
no class <class-name>
Function:
This command associates class to address pool in DHCPv6 address pool configuration mode and
enters class configuration mode in address pool. Use the no command to remove the link.
Parameters:
class-name, the name of DHCPv6 class.
Command Mode:
DHCPv6 address pool configuration mode
Usage Guide:
It is recommended to define this class first using global command of IPv6 DHCP class. No class will
be created if you input a class name which doesn’t exist.
Example:
Associate the DHCPv6 class named CLASS1 to dhcpv6 pool 1.
Switch(Config)#ipv6 dhcp pool 1
Switch(dhcp-1-config)#class CLASS1
29.1.3 ipv6 dhcp class
Command:
ipv6 dhcp class <class-name>
no ipv6 dhcp class <class-name>
Function:
This command defines a DHCPv6 class and enters DHCPv6 class configuration mode, the no
operation of this command removes this DHCPv6 class.
Parameters:
class-name, the name of DHCPv6 class which is a string with a length of less than 32
Command Mode:
Global configuration mode
Usage Guide:
Configure a group of option 37 or option 38, or configure option 37 and option 38 simultaneously in
a DHCPv6 class. This command can be used when the server supports DHCPv6 class only.
Example:
Define a DHCPv6 class named CLASS1.
Switch(Config)# ipv6 dhcp class CLASS1