Planet SGS-6341-24T4X - Page 475

31-114
31.3 ip prefix-list sequence-number
Command:
ip prefix-list sequence-number
no ip prefix-list sequence-number
Function:
Enable the sequence-number auto-creation function, the “no ip prefix-list sequence-number”
command close the prefix-list sequence-number.
Default:
Sequence-number auto-creation enabled.
Command Mode:
Global Mode
Usage Guide:
The command can be used to close the prefix-list sequence-number.
Example:
Switch(config)#no ip prefix-list sequence-number
31.4 match as-path
Command:
match as-path <list-name>
no match as-path [<list-name>]
Function:
Configure the AS path domain for matching the BGP routing messages. The “no match as-path
[<list-name>]”delete this configuration.
Parameter:
<list-name > is the name of access-list.
Command Mode:
route-map mode
Usage Guide:
This command matches the AS path domain of the BGP routing message following the rules
specified in the as-path list. If the matching succeeded, then the “permit” or “deny” action in the
route-map is performed.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5