Planet SGS-6341-24T4X - Page 500

33-139
Chapter 33 Commands for RIP
33.1 accept-lifetime
Command:
accept-lifetime <start-time> {<end-time>| duration<seconds>| infinite}
no accept-lifetime
Function:
Use this command to specify a key accept on the key chain as a valid time period. The “no
accept-lifetime” command deletes this configuration.
Parameter:
<start-time> parameter specifies the start time of the time period, of which the form should be:
<start-time>={<hh:mm:ss> <month> <day> <year>|<hh:mm:ss> <day> <month> <year>}
<hh:mm:ss> specify the concrete valid time of accept-lifetime in hours, minutes and second
<day> specifies the date of valid, ranging between 1 -31
<month> specifies the month of valid shown with the first three letters of the month, such as Jan
<year> specifies the year of valid start, ranging between 1993 - 2035
<end-time> specifies the due of the time period, of which the form should be:
<end-time>={<hh:mm:ss> <month> <day> <year>|<hh:mm:ss> <day> <month> <year>}
<hh:mm:ss> specify the concrete valid time of accept-lifetime in hours, minutes and second
<day> specifies the date of valid, ranging between 1 -31
<month> specifies the month of valid shown with the first three letters of the month, such as Jan
<year> specifies the year of valid start, ranging between 1993 - 2035
<seconds> the valid period of the key in seconds, ranging between 1-2147483646
Infinite means the key will never be out of date.
Default:
No default configuration.
Command Mode:
keychain-key mode
Example:
The example below shows the accept-lifetime configuration of key 1 on the keychain named
mychain.
Switch# config terminal
Switch(config)# key chain mychain
Switch(config-keychain)# key 1
Switch(config-keychain-key)# accept-lifetime 03:03:01 Dec 3 2004 04:04:02 Oct 6 2006