33-160
RIP routing protocol.
Default:
Not running RIP route.
Command Mode:
Global mode
Usage Guide:
This command is the switch for starting the RIP routing protocol which is required to be open before
configuring other RIP protocol commands.
Example:
Enable the RIP protocol mode
Switch(config)#router rip
Switch(config-router)#
33.34 send-lifetime
Command:
send-lifetime <start-time> {<end-time>| duration<seconds>| infinite}
no send-lifetime
Function:
Use this command to specify a key on the keychain as the time period of sending keys. The “no
send-lifetime” cancels this configuration.
Parameter:
<start-time> parameter specifies the starting time of the time period, which is:
<start-time>={<hh:mm:ss> <month> <day> <year>|<hh:mm:ss> <day> <month> <year>}
<hh:mm:ss> Specify the concrete valid time of accept-lifetime in hours, minutes and second
<day> Specifies the date of valid, ranging between 1 -31
month> Specifies the month of valid shown with the first three letters of the month, such as Jan
<year> Specifies the year of valid start, ranging between 1993 - 2035
end-time> Specifies the due of the time period, of which the form should be:
end-time>={<hh:mm:ss> <month> <day> <year>|<hh:mm:ss> <day> <month> <year>}
<hh:mm:ss> Specify the concrete valid time of accept-lifetime in hours, minutes and second
<day> Specifies the date of valid, ranging between 1 -31
<month> Specifies the month of valid shown with the first three letters of the month, such as Jan
<year> Specifies the year of valid start, ranging between 1993 -2035
<seconds> is the valid period of the key in seconding and ranging between 1-2147483646
Default:
No default configuration
To Next Page
Loading...
Need help?
General
Weight and Dimensions
